Setup - Greenlee 690 Instruction Manual

Setup

1. Unfasten the catches. Remove the motor cover and
remove the hose from the tank. Install the cover and
latch the catches.
2. Attach the storage box to the tank by positioning the
box over the triangular rib on the tank and sliding
the box down firmly until it locks into place.
Greenlee Textron / Subsidiary of Textron Inc.
690 and 690-22 Power Fishing Systems
Operation
• Wear eye protection and a dust
mask when operating the unit.
• Piston and debris will exit the
conduit at high speed. Attach the
warning tag at the exit end of the
conduit before using the unit.
Failure to observe this warning can
result in serious injury from flying
debris.
Use the 690 or 690-22 alone, or combine it with a
®
592 Mighty Mouser as shown here.
OPERATING TIPS
• When fishing through IMC or rigid, blowing is
generally more efficient than vacuuming.
• When fishing through EMT, vacuuming is the better
method. EMT connections are not airtight, and a
piston that is blown through might not reach the exit
end of the conduit run.
• Two fishing lines can be vacuumed in at the same
time, if desired. Leave one line in the conduit to pull
additional wire into the conduit after the initial
installation.
6 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070