Table of Contents
Advertisement
1
Operating the
appliance
P reparing the washing
O p e r a t i n g t h e a p p l i a n c e
machine
The washing machine must be
Note:
correctly installed and connected.
From ~ Page 13
Plug into the mains.
1.
Turn on the tap.
2.
Open the washing machine door.
3.
Check that the drum is completely
4.
drained. Drain if necessary.
Otherwise, the load display may
malfunction. ~ Page 51
Switching on the appliance/
selecting a programme
Press the # button. The appliance is
switched on.
The Bosch logo appears on the display
and all indicator lamps light up.
The Cottons programme set at the
factory is then always displayed.
You can:
use this programme or
■
select another programme on the
■
control panel or
select a programme under
■
Additional programs. ~ Page 25
If you have activated the
Note:
childproof lock, you must deactivate it
before you can set a programme.
Operating the appliance
The indicator lamp on the programme
selector lights up and the main menu
with the programme default settings
for the selected programme appear on
the display panel:
Temperature,
■
Spin speed,
■
Programme duration,
■
i-DOS settings,
■
Any additional settings and
■
Information on water and energy
■
consumption. ~ Page 12
In appliances with a drum light:
The drum is lit after switching on the
appliance, after opening and closing the
door and after starting the programme.
The light switches off automatically.
You can:
use the programme default settings
■
and load laundry ~ Page 42,
or change the programme default
■
settings and/or select additional
settings.
Change the programme
default settings
You can use or change the default
settings for each washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed. ~ Page 36
Pressing and holding the buttons
Note:
automatically runs through the set
values.
The settings are activated without
needing to be confirmed.
After the appliance is switched off, the i-
DOS settings for i I w and w are
retained. All other settings are not saved
and must be selected again.
Programme default settings
~ Page 29
en
41
Advertisement
Table of Contents
