Advertisement
Quick Links
Owner's Manual
3-IN-1 Multi-Purpose Mover
Covers 3-IN-1 Multi-Purpose Mover Models:
Model No.
MP3400
MP3400-VS
MP3401
MP3401-VS
MP3480
MP3480-VS
MP3481
MP3481-VS
NOTE: This manual references models with a 120V blower and "B" type electric plug. This
manual is also valid for 220V Airsled systems sold with the respective, country-specific
Description
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
3-IN-1 Multi-Purpose Mover
electrical cord/plug sets.
Lift rating
Speed
(lbs.)
2,300
Single
2,300
Variable
2,300
Single
2,300
Variable
2,300
Single
2,300
Variable
2,300
Single
2,300
Variable
Vacuum
Capability
No
No
Yes
Yes
No
No
Yes
Yes
Advertisement
Related Manuals for AIRSLED MP3400-VS
Summary of Contents for AIRSLED MP3400-VS
- Page 1 3-IN-1 Multi-Purpose Mover 2,300 Single MP3481-VS 3-IN-1 Multi-Purpose Mover 2,300 Variable NOTE: This manual references models with a 120V blower and “B” type electric plug. This manual is also valid for 220V Airsled systems sold with the respective, country-specific electrical cord/plug sets.
- Page 2 These conditions include the following: ✓ Surface is level and free of incline and/or decline. DO NOT attempt using your Airsled system on inclines, declines, ramps or stairs. ✓ Surface is smooth and non-porous and free of debris. Porous surfaces such as carpeting requires use of Airsled’s Rough Surface Adapters (RSAs).
- Page 3 The included spacer sticks are ½” thick and may adequately bridge the gap. For larger gaps, Airsled offers ADJUSTABLE SPACER SYSTEMS. More information on these items can be found on www.Airsled.com. Wood blocking can also be used to bridge the gap. •...
- Page 4 See figure 1. • BE PREPARED to brace and control the load once your Airsled system is activated. Using both hands to control and maneuver the load at all times is recommended. See figure 1.
- Page 5 GOING OVER POROUS SURFACES SUCH AS CARPETING All Airsled systems come with plastic Rough Surface Adapters (RSAs). The RSAs are 10” wide x 36” long and laid on top of the porous surface. The air beams MUST BE PLACED OVER THE RSAs in order for your system to perform properly.
- Page 6 Page 5 of 8 REPAIRS AND REFURBISHMENT Wear and tear over time especially with frequent use may cause components to fail. Airsled offers refurbishment services that can restore your aluminum air beams to as-new condition. More information can be found on www.Airsled.com. Due to safety and regulatory concerns, Airsled cannot refurbish the blower.
- Page 7 Page 6 of 8 Exhibit 1: Parts Diagrams Models: MP3400, MP3400-VS, MP3480, MP3480-VS Part No. Description PA01OF On/Off toggle switch On/Off variable speed dial (not PA01VS shown in diagram) PA00CA Front end cap PA01PC Power cord PA00CF Rear end cap and filter set 12”...
- Page 8 Page 7 of 8 LIMITED PRODUCT WARRANTY Airsled, Inc. (warrantor) uses the utmost care in the manufacturing of its products and this is warranted to be free from defects in material and workmanship, subject to the following limitations, qualifications and conditions.
- Page 9 This warranty is intended to comply with Federal Legislation relating to the contents and terminology in all warranties and shall be construed in a manner of consistent therewith. 70 – A Aleph Dr. Support Email: cs@airsled.com Toll Free Number: 1-800-AIRSLED (1-800-247-7533) Newark, DE 19702...
Need help?
Do you have a question about the MP3400-VS and is the answer not in the manual?
Questions and answers