Table of Contents
Advertisement
P A G E 4 8
R E F E R E N C E
Troubleshooting, cont'd
Some quick
and easy
tips to fixing
Remote control doesn't work.
problems
yourself.
Indicator light on remote
comes on but remote doesn't
transmit.
Menu options can't be
changed or selected.
No picture or sound
when any non-cable source
is selected.
Weak or no Stereo Sound
when using a stereo VCR.
Desired PIP source is not
selectable.
The PIP inset is black or
lacks contrast .
The PIP inset is "snow" when
the source is Ant/Cable 1 or 2.
Time is incorrect.
T R O U B L E S H O OT I N G
• Make sure the batteries are fresh and installed properly.
• Make sure the batteries are inserted in the remote properly.
• Try unplugging your Entertainment Machine for a few minutes,
then plug it back in.
• Check to see if the source equipment has been turned on.
• Make sure that the connections are secure on the back of your Entertainment
Machine and on the source equipment.
• Check to see if all the connections are secure.
• Look in the Audio mode menu to see if all the settings are correct.
• You are using channel 3 or 4 to view your VCR. No stereo sound is present
under that decision.
• Your Entertainment Machine automatically sets the PIP source to
Antenna/Cable 1 or 2 if that is the source for the main picture.
• You might want to adjust the PIP picture settings under the PIP menu.
• Check that all the wires are connected properly.
• Check to see if your input source for PIP is set correctly.
• Look to see if the TV/VCR button on your VCR has the TV selected.
• Automatic: Check to see if PBS Channel is correct and then check
Time Zone/Daylight Savings time settings under Clock menu. PBS station may
not be broadcasting time data (use manual setting).
• Manual: Make sure the time was set initially. Probably power was lost.
If all else fails, call 1-800-365-1690 Mon-Fri 7:00 am and 8:00 pm and Sat. 8:00 a.m. and 5:00 p.m. CST.
206-3360-O
Advertisement
Table of Contents
