Setting Saver; Vg-2 Mode; Laser Signature Id (Lsid) - Whistler GT-468GXi User Manual

OPERATION

Setting Saver

Setting Saver stores your personalized settings so that when the
detector is turned off and then on again, you do not have to
re-enter them.

VG-2 Mode

See Option Select Mode to turn this feature on/off. When a VG-2
signal is detected, the VG-2 alert is sounded and the display
flashes "VG-2". After 3 seconds the audio is canceled and the
display no longer flashes. This cycle is repeated if the VG-2 signal
is detected again .
During the period a VG-2 signal is detected, a radar signal
cannot be detected.

Laser Signature ID (LSID)

Identify the Laser gun's pulse rate or PPS (Pulses per Second) that
is transmitted by the speed laser gun. LSID may also be used to
identify other forms of laser sources such as LACC (Laser Assisted
Cruise Control) systems found in some high end vehicles. If the
Laser PPS information displayed is due to
another source such as local airports or LACC, LSID allows you
to Lock Out this rate from giving you the continuous audio alert
during this and any new encounter of the same rate.
To lock out a PPS, press the Quiet button during the Laser alert.
This will place an * on the screen beside the PPS rate and Lock
Out this signature ID. Any new encounter with the same Laser
Signature ID will provide the display information and two quick
beeps.
CAUTION: Do not lock out a PPS rate if it is close to known
speed laser guns.
22