Table of Contents
Advertisement
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the
Dryness and
at the same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the
repeatedly until you reach the
desired dryness level.
Dryness lev-
el
Maximum
dryness
Extra dry-
ness
10. CARE AND CLEANING
10.1 Cleaning the filter
At the end of each cycle the
symbol comes on the display and you
must clean the filter.
The filter collects the fluff
during the drying cycle.
To clean the filter:
1. Open the door. Pull the filter up.
Anticrease buttons
Start/Pause button
Display symbol
Filter
Dryness lev-
el
Standard
dryness
5. To memorise the setting touch and
hold down the
Anticrease buttons at the same time
for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down
and
Time Dry buttons at the
same time.
One of 2 configurations is possible:
• the Tank indicator:
symbol
water container indicator is
permanently activated
• the Tank indicator:
symbol
water container indicator is
permanently deactivated
2. Open the filter.
ENGLISH
15
Display symbol
Dryness and
Anticrease
is on if the
appears - the
is off if the
appears - the
Advertisement
Table of Contents
