KitchenAid KDFE104DSS5 Installation Instructions Manual page 15

WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
26.
Power cord – connect ground wire
Remove the ground connector screw on the raised floor inside
the box and place it through the ring terminal of the green
ground wire of power cord. Reattach and tighten the ground
connector screw to the raised floor of the box.
27.
Power cord – connect
remaining wires
Select UL Listed/CSA Approved twist-on wire connectors of
the proper size. See the "Tools and Parts" section at the front
of the guide for part details. Connect wires, black-to-black and
white-to-white, using the twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Ground
wire Ground
Washer
wire
Ground
screw
Wiring configuration
28.
Power cord – secure cord
on strain relief
Tighten strain relief screws to secure cord.
29.
Power cord – reinstall terminal
box cover and wires
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the
box and not pinched by the cover.
Put the terminal box back on the crossbar with the tab in
place. Use a / " nut driver and the screw removed in Step 22
1
4
to secure the terminal box to the crossbar.
Once the terminal box has been remounted on the dishwasher,
tuck any excess length or slack over nearby components or
clip them back into the nearby clips to help keep them off
the floor.
NOTE: Route power cord out the rear of the dishwasher. Do
not plug cord into an outlet until instructed to do so.
15