Table of Contents
Advertisement
Using tethering function
Use tethering function to enable the terminal
to use as modem to allow USB compatible
devices, wireless LAN devices or Bluetooth
devices to access the Internet.
❖ Information
If you want to use tethering, subscription to Packet
･
Pack/packet flat-rate service is strongly
recommended.
For details on usage charge, see the following
･
website.
https://www.nttdocomo.co.jp/english/
When the docomo nano UIM card is not inserted,
･
mobile data communication is disabled, or the
terminal is out of service area, USB tethering, Portable
Wi-Fi hotspot and Bluetooth tethering that use
mobile network are not available.
Setting USB tethering
From the Home screen,
1
u
[Settings]
[Tethering & portable hotspot].
Connect the terminal to the PC
2
with a USB compatible PC with
Micro USB Cable 01 (optional) etc.
(P.38).
When you connect microUSB cable etc.
･
for the first time, the driver software for
the terminal is installed to a PC. Wait for
a while until installation is completed.
u
u
[More]
When "Install software" screen appears
･
on the terminal, tap [SKIP].
Tap
of "USB tethering" or drag
3
it right.
❖ Information
System requirements (OS) for USB tethering are as
･
follows.
- Microsoft Windows 8/8.1
- Microsoft Windows 7
- Microsoft Windows Vista
- Linux
During USB tethering, the terminal storage cannot
･
be mounted with a PC.
USB tethering can be used with Wi-Fi tethering or
･
Bluetooth tethering at the same time.
Setting Wi-Fi tethering
From the Home screen,
1
u
[Settings]
[Tethering & portable hotspot].
Tap
of "Portable Wi-Fi
2
hotspot" or drag it right.
❖ Information
If Wi-Fi tethering starts while connecting to Wi-Fi
･
network or the terminal and DLNA device are
connected via Wi-Fi network, Wi-Fi network is
disconnected. Wi-Fi network is automatically
connected when Wi-Fi tethering ends.
Wi-Fi tethering can be used with USB tethering or
･
Bluetooth tethering at the same time.
u
u
[More]
Settings
153
Advertisement
Table of Contents
