Advertisement
Quick Links
Advertisement
Related Manuals for Glyph R22-1000
Summary of Contents for Glyph R22-1000
- Page 1 Ultra Wide Hard Drive Quickstart Manual...
- Page 2 (like drive specs, wiring schematics, pin outs ... stuff like that). Since opening your Glyph enclosure voids your warranty, our documentation covers the setup & use of the product, not the drive inside it.
- Page 3 Unpacking, Inspection & General Info Your Glyph drive and accessories are packaged in a sturdy shipping container. Please inspect the container for evidence of shipping damage and mishandling. If such evidence is found, file a report with the carrier or your...
-
Page 4: Parts Identification
You will be connecting cables and setting switches on the drive shortly, so it will be helpful to know the layout of the physical connections. Glyph drives come in tabletop & rack mounted configurations... yours looks like one of the following 5 enclosures. - Page 5 SCSI ID Switch Power Button SCSI Connectors Power Input SCSI ID Switches Power Button Fans SCSI Connectors Power Input...
- Page 6 Configuring your Glyph Ultra Wide Drive for Install Your Glyph ultra wide drive will interface with your SCSI card through the SCSI cable which is supplied with your drive, or with a cable specified by your ultra wide SCSI card manufacturer.
- Page 7 Make sure that the power is off on all of your computer equipment and the Glyph drive. Connect the power cable to the back of the Glyph drive. Plug the three prong power plug into an appropriate power receptacle, preferably with...
- Page 8 Carefully ... connect the SCSI cable to the Ultra Wide SCSI card which you have already installed. Then connect the remaining 68 pin end to the back of the Glyph drive in either the top or bottom 68 pin connector. These...
- Page 9 This is accomplished by adding active termination to the peripheral devices. Active termination can be implemented in many different ways. Glyph has supplied a small rectangular 68 pin terminator that plugs into the remaining 68 pin connectors on the back of the drive (or where ever the end of the daisy chain).
- Page 10 Setting the ID Switch Based on the previous discussion, you are now ready to set the SCSI ID Selector Switch on your new Glyph drive. The Glyph tabletop’s SCSI ID Switch is located over the power button, behind the sliding door on the front of the unit.
- Page 11 • Termination if necessary • The SCSI ID# set correctly Power up your Glyph drive. Rack mounted Glyph drives have power switches on the front panel. The Glyph tabletop’s power switch is behind the sliding door on the front of the enclosure.
- Page 12 Glyph Technologies Inc. • 2415 N. Triphammer Rd., #6 • Ithaca, NY 14850 607.275.0345 Fax 607.275.9464 1 1 2 2...