LED starts glowing, turn off the ionizer immediately and disconnect it from the mains. If water or other foreign matter enters the ionizer, turn off the master switch immediately and disconnect it from the mains. YBI-01A-BA-e-1620...
Page 4
Risk of injury! The peaks of the ion source are sharp and cutting. The ionizer generates poisonous ozone; ensure sufficient ventilation. For maintenance and repair work disconnect the ionizer from the mains. Disconnect the ionizer from the mains during periods of idleness. YBI-01A-BA-e-1620...
Page 5
The ionizer may heat up slightly during operation. Prior to ionising powdery goods to be weighed, turn off the fan. Ionisation results are better when the fan is turned on and the period required for discharging the sample will be shortened. YBI-01A-BA-e-1620...
0- 50 °C, 20 – 80 % air humidity (non-condensing) AC adapter (primary) AC 100-240V, 50 / 60Hz Rated electric power supply DC 12V, 500 mA Pollution Degree Overvoltage Category Category II Altitude Up to 2000 m Installation Site device may only be used indoors YBI-01A-BA-e-1620...
4 Appliance overview Ion source LED Ionizer operation (green = normal operation, red = breakdown) LED fan operation (yellow = on) Fan on- and off-switch Mains adapter connection Main switch YBI-01A-BA-e-1620...
5 Unpacking, Setup and Commissioning Unpacking Remove device carefully from packaging, remove plastic wrapping and place device at the planned work place. Scope of delivery 1. Ionizer 2. Mains adapter 3. Operating instructions Placing With adjustable feet Without adjustable feet YBI-01A-BA-e-1620...
Power is supplied via the external mains adapter. The stated voltage value must be the same as the local voltage. Only use original KERN mains adapters. Using other makes requires consent by KERN. Turn off the ionizer (master switch “OFF“) before connecting it to the mains adapter.
Discharge of goods to be weighed, glass wind screen or weighing containers. Discharge of beakers etc. Powdery samples are deposited at the inner wall of the glass when being poured into the beaker. This is prevented by discharging the beaker. YBI-01A-BA-e-1620...
Maintenance Service The appliance may only be opened by trained service technicians who are authorized by KERN. Before opening, disconnect from power supply. Disposal Disposal of packaging and appliance must be carried out by operator according to valid national or regional law of the location where the appliance is used.