Table of Contents
Advertisement
Using Your Radio
Privacy Code Scan
Your microTALK radio can automatically scan the Privacy Codes (either CTCSS 01 through 38 or DCS 01
through 83) within one channel. Only one set of privacy codes (CTCSS or DCS) can be scanned at a time.
To scan privacy codes:
Select Channel
1. While in Standby mode, press the Channel Up or Channel Down button to
choose the channel on which you wish to scan privacy codes.
2. Press the Scan button twice until either the CTCSS or the DCS icon appears on
the display and the privacy code numbers flash on the display.
Scan Button
3. Press the Channel Up or Channel Down button to begin scanning privacy
codes within the channel you selected.
During scanning (while receiving an incoming transmission), you can choose
from the following:
a. Press and hold the Talk button to communicate on that channel/privacy code.
Scan Privacy Codes
Your radio will remain on that channel/privacy code and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning privacy
codes. If you do not press any button within 10 seconds, your radio will
automatically resume scanning privacy codes.
c. Press the Talk/Call button to return to Standby.
Five Call Tone Settings
You can choose between five different Call Tone Settings to transmit a call alert.
To change a call tone setting:
Mode/Power
1. Press the Mode/Power button until the
letter "C" and the current call tone number
(01 through 05) is displayed. The current
call tone will sound for four seconds.
Call Tone Setting
2. Press the Channel Up or Channel Down button to hear the other
call tone settings.
3. Choose one of the following:
a. Press the Mode/Power button to enter the new setting and proceed to
Channel Button
other functions.
b. Press Talk or Call button to return to Standby mode.
c. Do not press any buttons for 12 seconds to return to Standby
mode.
12
English
Using Your Radio
Roger Beep Confirmation Tone
•
Your listener will hear an audible tone when you release the Talk button. This alerts the other party that
you are finished talking and it is ok for them to speak.
To turn roger beep on and off:
Mode/Power
1. Press the Mode/Power button until the Roger Beep icon flashes. The current on or
off setting is displayed.
2. Press the Channel Up or Channel Down button to select roger beep on or off.
3. Choose one of the following:
Roger Beep Off
a. Press the Mode/Power button to enter the new setting and proceed to other
functions.
b. Press the Lock button to transmit the call tone return to Standby.
Channel Button
c. Do not press any buttons for 12 seconds to return to Standby mode.
Key Tone On/Off
When Key Tone is On, an audible tone will sound each time a button is pressed.
•
To turn key tone on and off:
Mode/Power
1. Press the Mode/Power button until the Key Tone icon flashes. The current on or
off setting is displayed.
2. Press the Channel Up or Channel Down button to select key tone on or off.
Key Tone Off
3. Choose one of the following:
a. Press the Mode/Power button to enter the new setting and proceed to other
functions.
b. Press the Lock button to transmit the call tone return to Standby.
Channel Button
c. Do not press any buttons for 12 seconds to return to Standby mode.
•
•
13
Advertisement
Table of Contents
