LG DF22VV2 Owner's Manual page 53

Steam Functions (Steam Models)
Problem
Water drips from nozzle
when STEAM CYCLE
starts
Garments still wrinkled
after Steam Fresh™
Creases or pleats are
gone from garments
after Steam Fresh™
Garments have static
after using the Reduce
Static option
Garments are too damp
or too dry after using
the Reduce Static
option
Steam does not
generate, but no error
code is shown
Water drips from door
during STEAM CYCLE
Steam is not visible
during STEAM CYCLE
Drum does not turn
during STEAM CYCLE
Cannot see steam
vapor at the beginning
of cycle
Odors remain in
clothing after Steam
Fresh™
Possible Cause
This is normal.
Too many or overly different
types of garments in dryer.
The function of this cycle is to
remove wrinkles from fabric.
This is normal.
Correct drying options not
selected.
Water level error.
This is normal.
This is normal.
This is normal.
This is normal.
Steam Fresh™ did not remove
odor completely.
TROUBLESHOOTING
Solutions
This is steam condensation. The dripping
water will stop after a short time.
Small loads of 1 to 5 items work best.
Load fewer garments. Load similar types
of garments.
Use an iron to replace creases and pleats
in garments.
The amount of static experienced will
depend on the individual moisture level in
the skin.
Select the load weight manually before
starting the Reduce Static option.
Unplug dryer and call for service.
Condensation will normally form on the
inside of the dryer door during steam
operation. Some condensation may drip
out the bottom of the door.
Steam vapor is difficult to see when the
door is closed. However, condensation
will normally form on the inside of
the dryer door if the steam system is
operating normally.
The drum is turned off so that the steam
vapor remains in the drum. The drum will
normally turn for about 2 seconds once a
minute.
Steam is released at different stages of
the cycle for each option.
Fabrics containing strong odors should be
washed in a normal cycle.
53