Fluke 8846A Programmer's Manual page 57

[SENSe:]FRESistance[:DC]:FILTer:DIGital[:STATe](?) <n>
Description Activates or deactivates the digital averaging filter to improve noise
immunity for dc functions. This setting is stored in volatile memory.
Parameters <n>
Examples FRES:FILT:DIG ON
Query FRES:FILT:DIG?
[SENSe:]UNIT:TEMPerature(?) <units>
Description Sets the temperature units for the temperature function. This setting is
stored in volatile memory.
Parameters <units>
Examples UNIT:TEMP C
Query UNIT:TEMP?
[SENSe:]ZERO:AUTO <n>
Description Activates (default) or deactivates the autozero mode. This setting is stored
in volatile memory.
Parameters <n>
Examples ZERO:AUTO ON
Query ZERO:AUTO?
[SENSe:]VOLTage[:DC]:IMPedance:AUTO(?) <n>
Description Activates or deactivates (default) the automatic input impedance mode for
dc voltage measurements. With AUTO OFF, the input impedance is fixed
at 10 MΩ for all ranges. With AUTO ON, the input impedance is set to
>10 GΩ for the 100 mV, 1 V, and 10 V ranges. This setting is stored in
volatile memory.
Parameters <n>
Examples VOLT:IMP:AUTO ON Turns on automatic input impedance.
Query VOLT:IMP:AUTO?
= OFF or 0 Turns the digital averaging filter off.
ON or 1 Turns the digital averaging filter on.
Turns the digital averaging filter on.
Returns the digital averaging filter setting. (0 =
OFF and 1 = ON)
= Cel Sets temperature units to Celsius
Far Sets temperature units to Fahrenheit
Kel Sets temperature units to Kelvin
Sets temperature units to Celsius.
Returns the temperature units setting. (C =
Celsius, F = Fahrenheit, and K = Kelvin)
= OFF Turns Autozero mode off.
ON Turns autozero mode on.
ONCE Initiates a zero measurement immediately.
Turns autozero mode on.
Returns the state of the autozero mode. (0 = OFF
and 1 = ON)
= OFF or 0 Turns off automatic input impedance.
ON or 1 Turns on automatic input impedance.
Returns the state of the input impedance mode.
(0 = OFF and 1 = ON)
Digital Multimeter
Supported SCPI Commands
49