Gigabyte GA-EG43M-S2H User Manual page 52

Delay For HDD (Secs)
Allows you to set a delay time for the BIOS to initialize the hard drive as the system boots up. The
adjustable range is from 0 to 15 seconds. (Default: 0)
Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express
graphics card, or the onboard VGA.
PCI
Onboard
PEG
Onboard VGA
Enables or disables the onboard VGA function.
Enable If No Ext PEG
Activates the onboard VGA only if no PCI Express VGA card is installed. (Default)
Always Enable
Always activates the onboard VGA, whether or not a PCI Express card is installed. If you wish to
set up a dual view configuration, set this item to Always Enable.
On-Chip Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics
controller. MS-DOS, for example, will use only this memory for display. Options are:
32MB+2MB for GTT (default), 64MB+2MB for GTT, 128MB+2MB for GTT.
GA-EG43M-S2H Motherboard
Sets the PCI graphics card as the first display. (Default)
Sets the onboard VGA as the first display.
Sets the PCI Express graphics card as the first display.
- 52 -