Sony Ericsson K 500 Manual page 27

To activate voice answering and
record voice answer commands
} Settings } the General tab } Voice control
1
} Voice answer } Activate.
Instructions appear. } Continue and lift the phone
2
to your ear. Wait for the tone and say "Answer",
or another word. If the recording sounds ok
} Yes. If not } No and repeat step 2.
Say "Busy", or another word } Yes.
3
Instructions appear. } Continue and select
4
the environments in which you want voice
answering to be activated. You can select
several alternatives.
To answer a call using voice
commands
When the phone rings, say "Answer" and the call
is connected.
To reject a call using voice
commands
When the phone rings, say "Busy".
The call is rejected. The caller is diverted to
voicemail, if activated, or hears a busy tone.
This is the Internet version of the user's guide. © Print only for private use.
Editing your voice commands
You can keep all your voice commands up to date
by re-recording them or deleting the ones you do
not use. You can also edit a voice command for a
phone number in the phonebook. Select the contact
you want to edit a voice command for } More
} Edit contact. Scroll to the relevant tab and edit
your voice command.
To re-record a voice command
} Settings } the General tab } Voice control
1
} Voice dialling } Edit names.
Select a voice command } More } Replace
2
voice.
3 Lift the phone to your ear, wait for the tone and
say the command.
Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than one
syllable.
Calling
27