Advertisement
Manual Set Time
On rare occasions, in certain areas, the clock may not be able to receive
the radio controlled time signal due to the strength of the signal or the
geographic location. In this case, the clock can be set manually and
used as a regular quartz wall clock.
3 Battery
Compartments
Note: Allow up to five nights for the clock to receive the WWVB signal
before manually setting the time.
Set the clock manually:
1. Remove battery for 15 minutes and press the Time Set tab 20 times.
2. After 15 minutes, insert the battery and allow the clock to spin to
12:00, 4:00 or 8:00.
3. Hold the Time Set Tab and the hands will spin. Continue holding
until the correct time is achieved.
Note: You can only set the clock manually for about 2 minutes after the
battery is inserted. If the clock receives the WWVB time signal, this
signal will override manually set time.
Time Set Tab
Time Zone Buttons
Daylight Saving
Time Indicator
3 |
P a g e
Advertisement
