Fuel Shut Off Valve; Seat Adjustment; Cutting Height; Fuel Tanks - Husqvarna Z 572x Operator's Manual

CONTROLS

Fuel Shut Off Valve

The fuel shut-off valve is located at the right rear
of the seat. The valve has three positions: right
tank, left tank and OFF.

Seat Adjustment

The seat can be adjusted lengthways with the
lever located at the right hand side of the seat.
When making adjustments the lever is moved
upward.
Adjustments may be made to seat suspension by
turning the center knob.
IMPORTANT INFORMATION
be adjusted while unit is in motion.
Seat Release
The seat can be rotated forward to access the
mower battery and hydro gears. Pull up on the
latch lever to release the seat. Raise the seat until
the rod engages.
Seat must not

Cutting Height

The cutting height pedals release the deck lift and
set the desired deck height. Apply pressure to
the lift pedal (lower) and rotate foot to also apply
pressure to the release pedal (upper), unlocking
the deck lift.
For transport, push the lift pedal forward until the
deck lift latches in the transport (highest) position.
The cutting height can be set from 25.4 mm to
127 mm (1" to 5"). To set the deck cutting height,
press the button on the top of the height pin to
remove it. Slip the height pin into the hole for the
desired cutting height.
Release deck height control pedal by pushing it
forward.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.

Fuel Tanks

Read the safety instructions before refueling. The
capacity for each tank is 22.7 litres (6 gallons).
Regularly check the gas cap gasket for damage
and keep the cap properly tightened.
WARNING! Fill to bottom of filler neck.
Do not overfill. Wipe off spilled oil or fuel. Do
not store, spill or use gasoline near an open
flame.
The engine will run on a minimum of 87-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See
15