Battery; Bypass Protected Areas; Reset; Trouble Conditions - ADT Safewatch EZ Quick Manual

Safewatch EZ - Quick Guide
For more information on this topic please visit the complete

Battery

The Safewatch EZ operates on a
Loss of AC power and use of backup battery power is indicated by NO AC.
A low battery condition is indicated by BAT.
For instructions on replacing your battery, please go to the
battery.
For more information on this topic please visit the complete

Bypass Protected Areas

Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to
access a protected area when the system is armed.
To bypass a zone, press the [BYPASS].
Open the door you wish to be bypassed and then arm the system.
To unbypass a zone, unlock the deadbolt.
For more information on this topic please visit the complete

Reset

To silence an alarm and to clear memory of an alarm event, press the [SILENCE] button or insert and
remove the EZ-IFOB key into the IFOB slot. When the Armed light stops flashing, press [SILENCE] again to
clear the event.

Trouble Conditions

Trouble conditions are issues that require your attention and are indicated by beeping from your keypad
and the Trouble light flashing.
To display the trouble condition, press the [SILENCE] button and count the number of Trouble and
Ready flashes.
Use this number to refer to the Trouble Conditions table on your
If there is more than one Trouble Condition, press the [SILENCE] button again to view the next
Trouble Condition count.
If the system beeps once every 10 seconds, service is required.
For more information on this topic please visit the complete
https://alpha.adt.com/help/48[11/12/2018 4:18:57 PM]
UB 1270 battery.
Safewatch EZ manual.
Battery Replacement Page
Safewatch EZ manual.
Safewatch EZ manual.
Safewatch EZ system manual.
Safewatch EZ manual.
for this