Fujitsu Stylistic ST5110 User Manual page 20

Niechen_UG.book Page 9 Thursday, July 14, 2005 3:52 PM
In the following table, a "blinking" LED flashes at the rate of once per second; an LED that is "blinking, slow" flashes at the
rate of one second on, five seconds off.
Icon Mode/State
Battery • On State
• Idle Mode
• Suspend-to-RAM,
without AC adapter
• Suspend-to-RAM
with AC adapter
• Hibernate
(Save-to-Disk),
with AC adapter
• Off State
• Hibernate
(Save-to-Disk),
without AC adapter
HDD
• On State (or
flashing)
Access
• Idle Mode
• Suspend-to-RAM
• Hibernate
(Save-to-Disk)
• Off State
Security • On State
G e t t i n g S t a r t e d
LED State
Green, continuous Battery charge is between 50%-100%
Amber, continuous Battery charge is between 13%-49%
Red, continuous Battery charge is between 0%-12%
Red, blinking There is a battery error.
Green, blinking slow Battery charge is between 50%-100%.
Amber, blinking slow Battery charge is between 13%-49%.
Red, blinking slow Battery charge is between 0%-12%.
Off Battery is not installed, or system is off or in
Hibernate mode.
If battery is inserted during power off, LED blinks
amber for 4 seconds to detect battery. Battery
status is displayed for 5 seconds after that.
Green Displayed when hard disk drive is accessed.
Off Hard disk drive is not being accessed.
Green, continuous The Security Indicator lights (if a password was
(until password is set) when the system resumes from Off or
entered) Standby modes. You must enter the password
that was set in the Security Panel before your
system will resume operation.
Functions of Application Buttons on page 14 for
more information.)
Table 1-2. System Status Indicators
Remarks
(See Security
9