Table of Contents
Advertisement
OPERATION
SETUP
1. Remove steeping assembly
from kettle by aligning the
infuser tab arrows in the
unlocked position and lifting
up, by the infuser tabs.
2. Add water, filling for the
number of cups of tea you wish to make—
2 to 4 cups (max fill for tea is 1 Liter).
3. Remove tea infuser from holder by
turning the steeper lid, so
lid arrow lines up with
REMOvE. Lift infuser
cover to put the proper
amount of loose or bagged
tea into the tea infuser
based on how much water
was added.
NOTE: If using bagged tea
you can remove strings
and tags if desired. When
steeping 2-cups, make
sure ingredients are at the
bottom of the infuser so
that they fully immerse during steeping.
4. Return tea infuser to the infuser holder
so arrow lines up with REMOvE. Lock
the assembly in the raised position by
turning steeper lid counterclockwise so
arrow aligns with UP.
5. Insert the raised steeping assembly
into the kettle. Align the tab arrows and
turn the assembly clockwise to the
locked position with the infuser tabs.
HEATING WATER
1. Turn unit on by pressing Power button.
Make sure kettle is on the base.
2. Press Select button to scroll through and
select desired tea/temperature.
3. Press Temp Start to begin heat-up.
Selected temperature will flash during
heating. NOTE: Keep Warm will be
selected unless you deselect it.
See more information on page 6.
4. Once water reaches the selected
temperature, two beeps will sound,
indicating that the unit is ready to steep
tea. A recommended steeping time,
determined by the tea selected, will begin
flashing in the LCD display.
Note: Your unit will maintain the selected
temperature and continue flashing steep
time for 5 minutes. If Time Start is not
pressed, the unit will enter Keep Warm
mode.
STEEPING TEA
1. Recommended steeping time may be
adjusted. Press the Select button to
advance time in 30-second increments
up to 10 minutes. Press and hold the
button to scroll more quickly.
2. Once desired time
appears in LCD display,
lower the tea infuser into
the heated water by
turning the lid clockwise
so arrow lines up with DOWN; press
Time Start to begin countdown timer.
Water temperature will be maintained.
3. When the timer reaches 00:00 the unit
will beep 5 times. Raise the tea infuser
by turning the lid counterclockwise so
arrow aligns with UP. Keep Warm will
flash to indicate the unit has entered
Keep Warm mode.
4. Lift the kettle off the base to serve.
NOTE: When kettle is off base, lights will
flash to let you know the unit is paused.
5. When kettle is returned to base, the
Keep Warm cycle will pick up right
where it left off. NOTE: To turn the unit
off at any time, press the Power button.
Last selected settings will remain in the
unit's memory until the unit is unplugged.
HEATING WATER WITHOUT
STEEPING TEA
Remove steeping assembly and add water to
the kettle—max fill for water is
1.2 Liters. Cover with the
kettle lid, so that arrow on
kettle lid lines up with arrow
on the handle. Follow
directions for "Heating Water."
5
Advertisement
Table of Contents
