Table of Contents
Advertisement
Available languages
Available languages
8
operation
8.1 Switching the appliance on
In order to switch on the appliance push the mains plug into the socket.
8.2 Setting the temperature
The temperature can be set at from 0°C to 10°C. It is set by the knob.
noTE
Please note that the temperature will change depending on the
ambient temperature (installation site), the frequency of opening
the door and the fittings.
IMPoRTAnT
high room temperatures (such as e.g. on hot summer days)
and a cold temperature setting can lead to continuous
refrigerator operation. The reason for this is that the
compressor has to run continuously in order to maintain the
low temperature in the appliance. The appliance is not able
to defrost automatically because this is only possible when
the compressor is not running (see the defrosting section).
Therefore, a thick layer of frost or ice may form on the rear
interior wall.
8.3 noises during operation
normal noises
• Humming – the noise is caused by the compressor during operation.
It is loud when it switches on or off.
• Liquid noise – caused by the refrigerant circulating in the unit.
• Clicking noises – the temperature regulator switches the compressor
on or off.
32
9
Defrosting / Switching off
During the cooling and defrosting phases a thin layer of ice or drops
of water form on the inner wall. The condensation water flows into
a collecting tray and evaporates. Please ensure that the outflow
channel is not blocked. It can be cleaned carefully with a pipe cleaner
or a small brush.
Your refrigerator does have automatic defrosting, but if a thicker
layer of ice forms in-side the appliance – if you occasionally defrost it
by hand – proceed as described under point 10.1. Optionally, in order
to accelerate defrosting you can place a bowl with hot water in the
appliance or use a hairdryer.
10 Maintenance
10.1 cleaning and care
If the appliance is dirty, proceed as follows:
1. Before beginning with repair or cleaning works make sure the
device has been disconnected from power socket (pull the power
plug!!!) and has cooled down.
2. Clean the interior (including the rear wall and bottom) with warm
water and a mild cleaning product. Do not use any aggressive
cleaning products!
3. Dry all surfaces carefully.
4. After cleaning reconnect the refrigerator to the mains supply.
5. Never clean the appliance with steam cleaning equipment.
6. Regularly clean the refrigerator and aslo check the condensation
water outflow hole.
7. If the light is damaged, it must be replaced with a same size, power
and shape one. and must be replaced by the manufacturer or its
service agent.
33
Advertisement
Chapters
Table of Contents
