Advertisement
Quick Links
HEAVY DUTY ROUTER TABLE W013
OPERATING INSTRUCTIONS
AND
ASSEMBLY MANUAL
The Charnwood router table enables any portable router to be inverted
and used as a stationary machine capable of producing many different
types of joints and decorative finishes.
Charnwood, 1 Rowan Street, Leicester, LE3 9GP, England
Tel. 0116 251 1550 Fax. 0116 253 2891 e-mail; sales@charnwood.net
UK customers can view our full product range at www.charnwood.net
Advertisement
Related Manuals for Charnwood W013
Summary of Contents for Charnwood W013
-
Page 1: Operating Instructions
HEAVY DUTY ROUTER TABLE W013 OPERATING INSTRUCTIONS ASSEMBLY MANUAL The Charnwood router table enables any portable router to be inverted and used as a stationary machine capable of producing many different types of joints and decorative finishes. Charnwood, 1 Rowan Street, Leicester, LE3 9GP, England Tel. -
Page 2: Safety Instructions
15) TAKE EXTRA CARE WHEN SWITCHING - Watch what you are doing when turning the router on and off. The NVR switch available as an optional item is recom- mended to avoid the operator having to reach under the table to operate the switch. - Page 3 It will sometimes be necessary to obtain a reducing cone to match your hose to the outlet. If you are intending to use the router table without a dust collector it is better to leave off the dust chute to avoid a build up of wood shavings.
- Page 4 ROUTER MOUNTING INSTRUCTIONS i) MAKE SURE THE ROUTER IS UNPLUGGED. Remove the face plate cover from the router ( If your router does not have a removable face plate cover, measure the spacing of the fixing holes in the face plate and then mark out the insert plate, keeping the cutter aperture as the centre).
- Page 5 It is often eas- ier to do this by unscrewing the insert plate from the table and lifting the router out of the table. Draw a profile of the required cut onto the edge of the workpiece and adjust the cutter height to match.
- Page 6 SET THE CUTTER HEIGHT:- Fit the appropriate cutter into the router and set the plunge depth to give the desired cut. SET THE FENCE:- The cut is made away from the edge of the workpiece and therefore it will probably be nece- sary to move the Fence back into Position 2.