Table of Contents
Advertisement
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511V2H1
How to Configure an Ad-hoc Moce Profile
Note: Ad-hoc mode will not work using DHCP settings. Ad-hoc mode requires either static IP
addresses (such as
192.168.0.1)
parameters such as adding the IPX protocol support. For instructions on setting up static IP
addresses or IPX protocol settings on a Windows PC, please refer to the PC Networking Tutorial
included on the NETGEAR 54 Mbps Wireless PC Card WG511V2H1 Resource CD.
Follow the instructions below to configure an Ad-hoc mode profile.
1. Run the WG511V2H1 Configuration Utility.
Make sure the WG511V2H1 software is installed and the WG511V2H1 is fully inserted in an
a.
available CardBus slot in your PC.
Open the configuration utility by clicking on the
b.
system tray.
Figure 3-5: Configuration tab page Ad-hoc mode selected
Click the Configuration tab to display the view shown above.
c.
Select Ad-hoc from the Network mode drop-down list.
d.
Click Apply to apply your settings
e.
2. Save your settings in a Profile.
Click the Profiles tab to view the screen below.
a.
3-26
or other appropriate Windows networking configuration
WG511V2H1
icon
in the Windows
Configuration
Advertisement
Table of Contents
