Table of Contents
Advertisement
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511V2H1
Configure your WG511V2H1 and save the
Profile.
a. Click on the WG511V2H1 systray iconin the
to open the WG511V2H1 configuration utility.
The WG511V2H1 Wireless PC Card
configuration utility displays.
Change the Network Name SSID to
b.
match your network.
Tip: As an alternative to typing in the
SSID, you can use the Site Survey tab to
view the available wireless networks,
choose the one you want, and click the
Connect button.
Click the Profile tab. Enter a name for
c.
your profile.
Click the Save button to save all your
d.
settings in the Profile, and then click the
Activate button. You can save multiple
profiles and activate whichever one you
need to use.
Tip: If you use your notebook PC to
connect to a wireless network at work
and at home, create profiles called work
and home. Then, activate whichever one
you need for wherever you are located.
Click OK to close the utility.
e.
Note: This procedure assumes you are
connecting to a wireless network which is not
using WEP security. If your network includes
WEP settings, click the Security tab page and
configure the WG511V2H1 accordingly. For help with
these steps, please see
Security Features" on page 3-28
2-16
"Enabling Wireless
below.
Click here to open the configuration utility.
WG511V2H1 system tray icon
WG511V2H1 Configuration Utility
Note: The NETGEAR default settings are
Infrastructure mode, with NETGEAR for the wireless
network name SSID, and WEP disabled. If your WLAN
settings are different from the Netgear default settings,
you will not connect. Set up your
accordingly.
WG511V2H1
Basic Setup
Advertisement
Table of Contents
