Broan HRV200 ECM Installation Manual page 7

3. INSTALLATION (
CONT
3.2 L U
(
OCATING THE NIT
CONT
Trace a level line on the wall; align the wall bracket (the longer
one) to the line and secure this bracket to the wall using 4 provided
screws (1½" long) and washers, if using the slots on bracket).
!
Ensure the wall bracket is attached to all of the
available studs, not into the drywall alone.
L
EVEL LINE
VD0379
Using 1½" long provided screws, assemble both spacers to left and
right back bottom corner of the unit.
VD0380
CAUTION
Never use an electric screwdriver or
drill to screw the brackets to the unit;
use a standard screwdriver.
Using 3/8" long provided screws, mount the other bracket (A) to the
back of the unit; start with the 4 back screws, then 2 screws on top
left and right sides, then use the last center one to assemble the
last small bracket (B).
NOTE: These screws must be hand tightened.
B
A
VD0392
' )
D
' )
D
WARNING
W B
ALL RACKET
VR0086
U
NIT HUNG TO WALL BRACKET
Lift the unit and hang it to the wall bracket. Ensure the bracket
assembled on back of the unit rests on the wall bracket.
VO0271
Secure the unit to the wall using one 1½" long provided screw
through the small bracket.
VO0272
7