Advertisement
This set up guide contains installation instruction of the AMK DS81-A series of AMK's Dante System
enabled network self amplified speaker. This speaker is designed to use in plenum rated ceiling
spaces and can be dropped into standard square (2' x 2' or 600mm by 600mm) or rectangular (2' x 4"
or 600mm by 1200mm) false ceiling tile space with a tile bridge.
Important Safety Instructions.
WARNING: May result in serious injury. Installation and service must be performed by authorized
personnel only
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions.
5. Do not use this speakers near water
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with manufacturer's instructions.
8. Do not install these speakers near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
9. Use only attachments/accessories specified by manufacturer
10. If the speakers have not been used for some time, unplug the speakers. Or when there is a
lightning storms, please unplug the speakers for safety.
Parts Check List.
1 Speaker total with one main PoE operated speaker with three(1) passive speaker with
enclosures (The speaker enclosures are UL 2043 listed part no: PKG213-8QMA)
1 Speaker Grille
1 Handy Box Cover
1 Electrically isolated ceiling tile bridge.
When removing the speakers from the packaging, please make sure that you keep the paint masking
card board in a safe place for any painting that is to be done after the installation.
For Suspended Ceiling Installations
Remove the ceiling tile from the selected speaker location that is to be cut from the ceiling, and an
adjacent ceiling tile for access.
Installation Manual
DS81-A
Dante System Network Enabled Speaker
12407 Mukilteo Speedway, Ste. 130
Lynnwood, WA 98087
p. 800.438-4026 f. 877.721.8107
tech@amkspeakers.com
www.amkspeakers.com
Advertisement
Table of Contents
Related Manuals for AMK DS81-A-X
Summary of Contents for AMK DS81-A-X
- Page 1 Dante System Network Enabled Speaker www.amkspeakers.com This set up guide contains installation instruction of the AMK DS81-A series of AMK’s Dante System enabled network self amplified speaker. This speaker is designed to use in plenum rated ceiling spaces and can be dropped into standard square (2’ x 2’ or 600mm by 600mm) or rectangular (2’ x 4”...
- Page 2 Place the tile to be cut, finished side down, on a flat surface. Place the tile bridge, in the desired location, on back of the tile. Make sure the edges of the tile bridge will rest on the grid portion of the ceiling.
- Page 3 Main Active Speaker Wire Connection: Connect the audio wires connecting active speakers to three passive speakers through conduit. Pre terminate the wire and connect the Phoenix plug to the wire. Punch the knockout on the side of the handy box. After the connection is made, make sure to close the handy box with the cover provided. The audio wires should be a two conductor wire with recommended 18 AWG wire.
- Page 4 Warranty The speakers should be not open, altered, tampered without the consulting with AMK, otherwise you will lose the warranty on the speaker. If the speaker is a need for additional support for seismic...
Need help?
Do you have a question about the DS81-A-X and is the answer not in the manual?
Questions and answers