Surround Sound - LG SN7Y Owner's Manual

,
Note
y If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the main unit and wireless receiver away from
there.
y The wireless receiver will automatically switch
to standby mode in a few minutes after the
sound bar is turned off.
When the wireless receIver is in standby
mode, the LED will turn on in red.
y When you turn on the sound bar, the wireless
receiver will turn on and the LED will change
to yellow - green and then the rear speakers
makes sound within a few seconds.
y It takes a few seconds (and may take longer)
for the main unit and Wireless Receiver to
communicate with each other.
y Use the rear speaker at least 30 cm away
from either TV screen or PC monitor.
y When the wireless receiver is being
connected or disconnected with the main
unit, output sound may be interrupted.
y Set the distance between the sound bar and
the wireless receiver as close as possible and
keep them away from the device (ex. wireless
router, microwave oven, etc.) over 1 m to
prevent wireless interference.
1 m

Surround sound

You can enjoy magnificent surround sound for all the
input sound source with rear speakers.
If you turn on the surround function, the whole
speaker outputs sound.
When you turn off the surround function, the
speakers output sound as an original input sound
channel.
To turn on surround function, press and hold
the remote control for about 3 seconds and press it
once again while "OFF - SURROUND" is scrolled.
To turn off surround function, press and hold
the remote control for about 3 seconds and press it
once again while "ON - SURROUND" is scrolled.
Connecting 21
on
2
on