AEG COMFORTLIFT 9000 User Manual page 11

not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press .
• The indicators
are off.
• The indicator
• The display shows the current
setting:
– = Acoustic signal off.
– = Acoustic signal on.
3. Press to change the setting.
4. Press on/off to confirm the setting.
6.5 How to set the colour of
the TimeBeam
The appliance must be in programme
selection mode.
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
.
• The indicators
are off.
• The indicator
and until
, , , and
, , and
still flashes.
and until
, , , and
, , and
still flashes.
• The display shows a number and
letter C. Each number refers to a
different colour.
– = TimeBeam
deactivated.
3. Press repeatedly to change the
colour.
4. Press on/off to confirm the setting.
6.6 AirDry
AirDry improves the drying results with
less energy consumption.
During the drying phase, the
door opens automatically
and remains ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.
AirDry is automatically activated with all
programmes excluding
To improve the drying performance refer
to the XtraDry option or activate AirDry.
CAUTION!
If children have access to the
appliance, it is advised to
deactivate AirDry as opening
the door may pose a danger.
How to deactivate AirDry
The appliance must be in programme
selection mode.
ENGLISH 11
.