Table of Contents
Advertisement
Operating the product
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Washing time can
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the
dishes.
C
Pay attention not to open the
door of the machine when it is
running. There may be a rush of
vapour when you open the door
of your machine; be careful.
C
The machine will remain silent
in pause mode for some time
in order to remove the water
from the machine and on the
dishes completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.
Cancelling the programme
Open the door of the product Press
and hold the Programme Selection /
Programme Cancel keys for 3 seconds.
After the 3 - 2 - 1 countdown, 0:01 is
displayed, close the door of the product
and wait for the draining process complete.
Draining is completed in 2 minutes and the
machine gives an audible warning when it
is completed.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Dishwasher / User's Manual
Salt indicator ( )
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of
rinse aid
1.
After turning on the machine,
press Time Delay and P+ keys
simultaneously. After the countdown
(3, 2, 1) is displayed keep the keys
pressed for a while.
2. Press P+ to move to position (P) on the
display.
3. Set to the appropriate level with the
Time Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
29 / 43 EN
Advertisement
Table of Contents
