Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Workrite Ergonomics Poise PA1000
Summary of Contents for Workrite Ergonomics Poise PA1000
- Page 1 Installation Instructions Workrite Poise™ #1500138 - Rev. F...
- Page 2 LCD monitor is detached. Do not attempt to disassemble, service or modify the product by yourself. Use only a slightly damp cloth to clean the Arm surface. Never apply flammable solvents like alcohol, benzene, thinner, etc. to the product. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 3 Wing Nut U Bracket M4 Hex Wrench M8 Flat Head Cap Screw Holding Tab Round Head Cap Screw M4 6mm Screw M4 10mm Screw Cable Clip M5 10mm Set Screw M3 6mm Screw M2.5 Hex Wrench Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 4 Put Desk Base directly on the bolting hole of work surface and tighten (f)M8 Thread Rod with (h)M4 Hex Wrench. Insert (E)U Bracket & (c)Washer through (f)M8 Thread Rod and tighten them with (g)Wing Nut. 4 Follow Desk Mount Steps 4 to 8. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 5 LCD monitor might not be suitable for the M4 screws provided by our Product. Using unsuitable mounting screws might cause damage to the LCD monitor. Please consult your LCD monitor manufacturer if you have enquires. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 6 M3 Screws (o) and put monitor cables, leaving slack cables into the Cable Clip. for monitor cables to move freely. M3 Screws Strip Strip Note: To allow free movement of monitor and Arm/Extension, please leave sufficient slack in the cables. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 7 If the Arm tends to rise, the M5 Hex Wrench should be turned clockwise to decrease the tension until the Arm reaches a stable position. If the Arm tends to fall, the M5 Hex Wrench should be turned counter-clockwise to increase the tension until the Arm reaches a stable position. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
- Page 8 Drill hole at least ½" in diameter 2" Workrite reserves the right to make changes to its products without notice. No liability is assumed for any misprinting or error in this publication. Copyright 2009. All rights reserved. Workrite Ergonomics 800.959.9675 www.workriteergo.com...
Need help?
Do you have a question about the Poise PA1000 and is the answer not in the manual?
Questions and answers