Workrite Ergonomics PA4000 Assembly Instructions

PA4000 - Poise Twin Assembly Instructions
(PA3000 - Poise HD Arm + PATWIN-B Wing Bracket)
A
Wing Bracket
Qty: 1
1
Attach the Wing Bracket (A) to the Poise
HD forearm VESA 100 Mount using the four
M4x10mm screws (C) (horizontal orientation
shown) . Be sure to tighten securely. Attach
M4x8mm screw and washer (E) to lock pivot.
E
E
Horizontal
Note: It is strongly recommended to use the mounting screws provided by the LCD monitor manufacturer. Due to the variety of
!
monitor mounting designs, the mounting holes at the back of the LCD monitor might not be suitable for the M4 screws we have
provided and could cause damage to the LCD monitor.
B
LCD Mount
Qty: 2
C
A
Vertical
C D
M4x10mm Screw M4x6mm Screw
Qty: 12 Qty: 10
2
Attach each LCD Mount to the monitors with four
M4 screws (C or D). Be sure both LCD Mounts
are aligned in the same direction for the selected
Wing Bracket orientation.
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
#1500155 - Rev A
E
M4x8mm Screw and Washer
Qty: 1 each
C or D
Orient LCD Mount
!
with widest edge
aligned to top of
monitor when mounting
B
Wing Bracket horizontally.
B