Electrolux FPEH3077RF Installation Instructions Manual page 4

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket
is to be mounted to the wall, drill pilot hole at an
approximate 20° downward angle. If bracket is to
be mounted to masonry or ceramic fl oors, drill a
3/16" pilot hole 1-3/4" deep. The screws provided
may be used in wood or concrete material. Use a
5/16" nut-driver or fl at head screwdriver to secure
the bracket in place.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
Leveling leg
Floor Mount
FASTEN BRACKET
(FLOOR MOUNTING ONLY)
Leveling leg
Floor Mount
1-1/4" Max.
Wall mount
Wall Plate
Anti-Tip Bracket
More than
1-1/4"
Wall
Anti-Tip Bracket
Figure 2
C. Level and position the range - Slide range to its
fi nal position. Insert the range leveling leg in the anti-
tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven
rack. Take 2 readings with the spirit level placed
diagonally; take a reading in one direction and then
in the other direction. Level the range if necessary by
adjusting the leveling legs.
Range side
Figure 4
Leveler
4
Figure 3
Leg
Raise
Lower
Figure 5