Error Messages - LG TH2112DSAB Owner's Manual

Error Messages

Symptoms
40
Reason
The door is not closed
properly.
Door lock switch error.
Special Drain Feature.
Water supply taps are not
fully open.
Water line hoses are kinked,
pinched, or crushed.
Water inlet filters are
clogged.
Water supply pressure to tap
or house is too low.
Water supply connected with
leaklimiting hoses.
Foreign objects, such as
coins, pins, clips, etc., caught
between the wash plate and
the inner basket.
Drain hose is kinked,
pinched, or clogged.
Drain discharge is more
than 1.2 m above bottom of
washing machine.
UE rebalancing operation is
not successful.
The load is too small.
Heavy articles are mixed with
lighter items.
The load is out of balance.
Control error.
Solution
• Close the door completely. If the error code is
not released, call for service.
• Check nothing is caught under the door,
including shipping materials or lothing.
• Close the door completely. If the error code is
not released, call for service.
• If the washing machine is paused during a cycle
for a few minutes, the cycle will be cancelled
and any water remaining in the drum will be
drained.
• Fully open tap.
• Straighten the hose(s).
• Clean the inlet filters.
• Contact a plumber to have the water lines
repaired.
• Do not use leak limiting hoses.
• Turn off the washing machine and then press
the POWER button. Press the Spin button
without selecting a cycle to drain and spin the
load. When the spin is complete, remove the
clothes and then find and remove any objects
caught in the wash plate.
• Straighten the hose(s).
• Adjust or repair drain. Maximum drain height is
1.2 m.
• The automatic attempt to rebalance the load
was not successful. The cycle has been paused
to allow the load to be manually adjusted.
• Add more items to allow the washing machine to
balance the loads.
• Wash articles of somewhat similar weight.
• Manually redistribute the load if articles have
become tangled.
• Unplug the washing machine and wait 60
seconds. Reconnect power and try again. If the
error code is not released, call for service.
EN