Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Air conditioner will not operate
Ineffi cient or no cooling
Noisy unit
Odors
Water dripping outside
Water dripping inside
Ice or frost build-up
NOTES:
1. If circuit breaker is tripped repeatedly, or fuse is blown more than once, contact a qualifi ed technician.
2. When the unit is installed using proper installation steps, the unit is properly tipped toward the outdoors to allow for
condensation run-off.
Tel: 1-800-26-
POSSIBLE CAUSE
•
No power to the unit
•
Dirty air fi lter
•
Unit size inappropriate for appli-
cation
•
Blocked air fl ow
•
Power interruption, settings
changed too quickly, or compres-
sor overload tripped
•
Loose parts
•
Inadequate support
•
Formation of mold, mildew, or
algae on wet surfaces
•
Hot and humid weather
•
Unit is not properly angled to
allow water to drain outside
•
It is an extremely humid day
•
Low outside temperature
•
Unit air fi lter is dirty
9
(1-800-263-2629)
•
Check connection of power cord
to power source.
•
Check fuse or circuit breaker.
•
Set SELECTOR SWITCH to
position other than "OFF". The
power cord "RESET" button must
always be pushed in (engaged)
for correct operation.
•
Clean/replace air fi lter
•
Check with dealer to determine
proper unit capacity for application
•
Remove obstruction from grill or
outdoor louvres
•
Turn the unit off and wait 5 min-
utes before attempting to restart
•
Tighten loose parts
•
Provide additional support to unit
•
Clean unit thoroughly
•
Place algaecide tablet in base pan
•
Condensation run-off is normal
under these conditions.
•
Unit must be installed on an angle
for proper condensation run-off.
Check the unit and make any
adjustments.
•
On an extremely humid day, this
effect is expected. No action
required.
•
When outdoor temperature is
approximately 18.3°C (65°F) or
below, frost may form when unit is
in cooling mode.
•
Remove and clean fi lter
SOLUTION
Advertisement
Table of Contents
