Use Your Tv; Switching On Your Tv And Putting It In Standby Mode; Adjusting Volume; Switching Channels - Magnavox 55ME345V Owner's Manual

4 Use your TV

Switching on your TV and putting it in Standby
mode
TV
Remote Control
To Turn the TV On from Standby or Off to Standby
Press B on the Side of the Unit or the Remote Control.
●
Note(s)
Energy Consumption contributes to air and water pollution. When the AC Power Cord
●
is plugged in, your TV consumes energy with a very low Standby Power Consumption.

Adjusting Volume

TV
Remote Control
55" - 43"
To decrease or increase Volume
Press VOL J (–) / K(+) on the Side of the Unit or press VOL + / – on
●
the Remote Control.
VOL J(–) : Volume Down
VOL K(+) : Volume Up
To mute or unmute sound
Press D on the Remote Control to mute the sound.
●
Press D again or VOL + / – to recover the original sound.
●

Switching Channels

To select Channels by using CHI / H or CH + / –
Press CH I(–) (Down) / H(+) (Up) on the Side of the Unit or press
●
CH + / – on the Remote Control.
To select Channels by using the NUMBER keys
For Digital channels, press a number followed by a dot "•" and the
●
corresponding sub channel number.
–
32"
–
Press PREV.CH to return to the previously viewed channel.
To select the non-memorized channels, use the NUMBER keys.
●
No signal will appear on the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive only a
●
sound signal.
TV
Remote Control
55" - 43"
Digital TV Operation
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
When selecting Cable or Analog channel 11
Note(s)
17 .
English
32"
Continued on next page.