3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote control
To turn the TV on from standby or off to standby
Press B on the unit or the remote control.
●
Note(s)
Energy consumption contributes to air and water pollution. When the AC power
●
cord is plugged in, your TV consumes energy with a very low standby power
consumption.
Adjusting volume
TV
Remote control
To decrease or increase volume
Press VOL J / K on the unit or press VOL + / – on the remote
●
control.
VOL J (–) : Volume down
VOL K (+) : Volume up
To mute or unmute sound
Press D on the remote control to mute the sound.
●
Press D again or VOL + / – to recover the original sound.
●
Switching channels
TV
Remote control
To select channels by using CHI / H or CH + / –
Press CH I (down) / H (up) on the unit or press CH + / – on the
●
remote control.
To select channels by using the NUMBER keys
Digital TV operation
For digital channels, press a number followed by a dot "•" and
●
the corresponding sub channel number.
When selecting digital channel 11.1
–
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
When selecting cable or analog channel 11
–
Press PREV.CH to return to the previously viewed channel.
Note(s)
To select the non-memorized channels, use the NUMBER keys.
●
No signal will appear on the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive only
●
a sound signal.
16
.
English
Continued on next page.