Table of Contents
Advertisement
Project Name
SIACP VERSION
Chassis
PANEL NAME
PROJECT ID
CONFIG
USB UPDATE
HOTEL ENABLE
ReloadEFBItem
CONFIG submenu
ITEM
Default
Setting
Erase HDCP Key Do
Reset HDCP Key Do
UsbHdcpkey
Do
Update
5. Debugging
5.1. General Steps of debugging
According to the requirement of the order, below steps are needed for
appropriate setting.
1) Enter the Factory Menu, enable FAC HOTKEY.
2) Check Project ID and the version of software, release date displayed
at the bottom of Factory Menu.
3) Enter Design Menu, choose SERVICE MENU->Project ID, choose
corresponding Project ID number of the product (Refer to the
"V6-PROJECT -ID0**"in the BOM list).
4) Return to Factory Menu, check the Product model.
5) Choose Factory Menu->NVM RESET and press the right button of the
remote and wait until prompt OK appears.
6) Restart the set
7) According to the requirement of the order, Set the items of SHOP
INIT and Hotel Menu etc.
8) After aging under normal temperature, calibrate ADC and adjust
white balance.
Module name
SIACP VERSION
MS306
Chassis name
P/N of panel
>>>
Select panel ID Number
>>>
Project Select submenu
>>>
USB UPDATE
HOTEL MENU SWITCH
OFF
Do
Only for factory adjust
Description
Only for R&D
Only for R&D
Only for R&D
OK
OK
OK
OK
NG
OK
ok
NOT
USE
OK
Status
OK
OK
OK
Advertisement
Table of Contents
