Table of Contents
Advertisement
If your 802.11n Wireless LAN USB Card performs as enrollee, choose "Join a WLAN (Enrollee)"
and click on Next. You will have two methods to join a WPS-enabled AP.
Push Button on AP: Push the button on the Access Point and then click
on the client
utility to start WPS link within 2 minutes. If WPS link is established successful, it will display the
success message.
Instead of Push Button on AP, you may use USB-N11's hardware push button to establish WPS link
as well. Push the button on the Access Point and press PBC button on the client to start WPS
link within 2 minutes. If WPS link is established successful, it will display the success message
figured below.
Client's PIN Mode: Select PIN and then the PIN key field will generate a dynamic PIN code
automatically. Input the PIN key into the Access Point PIN key field, and apply change. Click
to start WPS link progress.
45
Advertisement
Table of Contents
