FrSky D8RSP Instruction Manual

1.

Introduction

1.1 Compatibility

Compatible with FrSky two way telemetry modules: DFT, DJT, DHT, DHT-U

1.2 Specifications

Dimension: 56*25*14mm
Weight: 12.2g
Operating Voltage Range: 3.5V-10.0V
Operating Current: 100mA
Operating Range: 1.5km
Resolution: 3072 (>11bit)
2.

Set up

2.1 Bind procedure

1) Ascertain that the transmitter is in the PPM mode. Turn off the transmitter.
2) Turn on the transmitter while holding the F/S button on the transmitter module (Ensure that both
switches on the transmitter module are OFF when using D8RSP in two way mode). Release the button.
The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the
receiver.
3) Connect battery to the receiver while holding the F/S button on the receiver. The LED on the
receiver will flash, indicating the binding process is completed. Turn off both the transmitter and the
receiver.
4) Turn on the transmitter and connect the battery to the receiver. The RED LED on the receiver
will indicate the receiver is receiving commands from the transmitter. The receiver/transmitter module
binding will not have to be repeated, unless one of the two is replaced.
Instruction Manual for FrSky D8RSP
www.frsky-rc.com