• Place Control Panel Assembly onto Smoker Chamber by placing tabs under the front edge of the Smoker Chamber. The
Control valve must engage the burner venturi tube as shown A.
• From the inside of the Smoker Chamber, Install 2 #10-24x3/8" screws through the smoker chamber and through the
3
Control panel Tabs as shown. Thread 1 #10-24 Keps Nut onto each screw and tighten As shown B. Install 2 #10-24x3/8"
screws through the control panel tabs and into the burner assembly housing. Thread 1 #10-24 Keps Nut onto each screw
and tighten securely. Shown B
A
• Be sure the electrode wire exits the hole UNDER the venturi tube hole. DO NOT route the wire through the same hole as
4
the burner venturi tube.
• Install Ignitor Wire by pushing the round connector onto the Ignitor as shown.
Rotary ignitor
Push the
Round end
of ignitor wire
onto the
Rotary Ignitor
hole under the
Venturi Tube
14 • 10201597-50
Control
Valve
Control
Panel Tabs
Control Panel
Screw Hole
Route wire
through
Hole
B
#10-24x3/8" Screws
Qty: 4
#10-24x3/8" Screw
NOTE: Hose not shown
Install 1 #10-24x3/8"
Screw per side
Burner Assembly
Housing
Qty: 4
#10-24 Keps Nut
for clarity
Control Panel
Shown Installed