TP-Link RE200V4 User Manual page 49

Q5 I have enabled wireless MAC filter, wireless access control, or access
control list (ACL) on my router What should I do before configuring
the extender?
When a device connects through the extender to your router, the MAC address of the
device shown on the router is translated to another MAC address. If your router's MAC
filter, wireless access control, or ACL is enabled, the devices connected to the extender
cannot get an IP address from the extender and cannot access the Internet.
To solve this problem, please follow the steps below:
1. Log in to your router and disable the MAC filter, wireless access control or ACL.
Note: For more information about how to disable your router's MAC filter, wireless access control or ACL, please refer
to your router's user guide.
2. Power on your extender, and run the
3. Connect all of your devices to the extended network.
4. On your router, add all the Online Devices' MAC addresses to your router's MAC filter
table.
5. Enable the router's MAC filter, wireless access control, or ACL to complete the
configuration.
Quick Setup to configure your extender.
46