Operation - Simpson Water Shotgun WS5050H 49-State Instruction Manual

Professional pressure washer
Table of Contents

Advertisement

1.
Locate and remove all loose parts from the carton.
2.
Remove the colored quick-connect or MEG nozzles (if included) from the
plastic manual bag and insert them into correct grommet on the nozzle
holder (if equipped). Quick connect nozzles are color coded and will
match the nozzle holder label.
3.
Connect wand to gun and tighten securely.
4.
Attach high pressure hose to gun and tighten securely.
NOTICE: The engine is shipped without oil. Before starting engine, add the
provided oil. Damage to the engine will occur if the engine is run without oil.
This damage will not be covered under warranty.
NOTICE: The high-pressure pump was filled with oil at the factory. Always check
oil level before using (refer to Maintenance for more information).
IF EQUIPPED WITH ELECTRIC START
1.
Place the battery into the battery box. NOTE: Battery is not supplied, purchase
a 12V garden tractor battery with an ampere rating of at least 18 AH.
2.
Make sure the battery boots are on the battery cables before connecting to battery.
a. Connect the positive (red) battery cable to the positive (+) battery terminal.
IMPORTANT: ALWAYS CONNECT THE POSITIVE (RED) CABLE BEFORE
CONNECTING THE NEGATIVE (BLACK) CABLE. NEVER CONNECT THE
NEGATIVE (BLACK) CABLE FIRST.
b. Connect the negative (black) battery cable to the negative (-) battery terminal.
c. Grease the battery terminals and cable ends.
Slide the batter boots over the battery terminals.
PRESSURE WASHER TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
GPM: Gallons per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is
not pulled. This feature allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between cleaning actions.
ASSEMBLY INSTRUCTIONS (FIG. 2)

OPERATION

9 - ENG

Advertisement

Table of Contents
loading

Table of Contents