Electrolux EW6S4603BM User Manual page 7

6. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holder.
WARNING!
It is possible to see
water flowing from the
drain hose. This is
because the washing
machine has been
tested at the factory.
7. Remove the four transit bolts and pull
out the plastic spacers.
8. Put the plastic caps, that you find in
the user manual bag, in the holes.
1
2
3.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
The inlet hose
2
1
We recommend that you
keep the packaging and
the transit bolts for any
transport of the appliance.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
CAUTION!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
ENGLISH 7