Related Manuals for Smeg D72302P
Summary of Contents for Smeg D72302P
- Page 1 Notice d'utili‐ Benutzerin‐ User Manual sation formation Réfrigéra‐ Fridge Kühl - Ge‐ teur/congéla‐ Freezer frierschrank teur D72302P...
-
Page 2: Table Of Contents
CONTENTS Safety information Hints and tips Safety instructions Care and cleaning Operation Troubleshooting First use Installation Daily use Technical information Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. -
Page 3: Safety Instructions
Do not use mechanical devices or other means to accelerate • the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. - Page 4 electrician to change the electrical • Obey the storage instructions on the components. packaging of frozen food. • The mains cable must stay below the Internal light level of the mains plug. • Connect the mains plug to the mains •...
-
Page 5: Operation
OPERATION Switching on 1. Turn the Temperature regulator toward lower settings to obtain the minimum 1. Insert the plug into the wall socket. coldness. 2. Turn the Temperature regulator 2. Turn the Temperature regulator toward clockwise to a medium setting. higher settings to obtain the maximum coldness. - Page 6 The freezing process lasts 24 hours: during this period do not add other food to be frozen. When the freezing process is completed, return to the required temperature (see " Function"). In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting.
-
Page 7: Hints And Tips
1. Fill these trays with water After putting fresh food into the 2. Put the ice trays in the freezer appliance or after opening the compartment. door repeatedly or for a long period, it is normal for the Thawing indicator not to show "OK"; wait at least 12 hours before Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator... -
Page 8: Care And Cleaning
• the freezing process takes 24 hours no • it is advisable to show the freezing in further food to be frozen should be date on each individual pack to enable added during this period; you to keep tab of the storage time. •... - Page 9 every time the motor compressor stops, 2. Remove any stored food, wrap it in during normal use. The defrost water drains several layers of newspaper and put it in out through a trough into a special a cool place. container at the back of the appliance, over WARNING! Do not touch the motor compressor, where it evaporates.
-
Page 10: Troubleshooting
WARNING! If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. TROUBLESHOOTING WARNING! Refer to Safety chapters. What to do if... Problem Possible cause Solution... - Page 11 Problem Possible cause Solution Food products are not Wrap the food products better. wrapped properly. Temperature is set incor- Refer to "Operation" chapter. rectly. Water flows inside the refrig- The water outlet is clog- Clean the water outlet. erator. ged. Food products prevent that Make sure that food products water flows into the water...
-
Page 12: Installation
maximum power is shown on the lamp 2. If necessary, adjust the door. Refer to cover). "Installation". 4. Install the lamp cover. 3. If necessary, replace the defective door 5. Tighten the screw to the lamp cover. gaskets. Contact the Authorised 6. - Page 13 Door reversibility Do a final check to make sure that: 1. Loosen and remove the upper pin. • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e.
- Page 14 7. Attach the appliance to the niche with 4 screws. 8. Remove the correct part from the hinge cover (E). Make sure to remove the part 4. Push the appliance in the direction of DX, in the case of right hinge, SX in the arrows (2) against the cupboard on opposite case.
- Page 15 17. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 10. Install the vent grille (B). 11. Attach the hinge covers (E) to the hinge. 90° 12. Connect the appliance laterally to the kitchen furniture sidewall. 13.
-
Page 16: Technical Information
8 mm 22. Remove the brackets and mark a 25. Press the part (Hd) on the part (Hb). distance of 8 mm from the outer edge of the door where the nail must be fitted (K). 8 mm Do a final check to make sure that: •...