Page 1
Full-auto shut off brushed electric screwdrivers Instruction Manual Applicable Models: AT-6000, AT-6500, AT-6800 Thank you ■ for purchasing the CHP electric screwdriver. In order to ensure maximum performance and product life, please read this manual before operating your screwdriver.
Table of contents General Safety Warnings ......................... Care/Maintenance…………………………………………………………………………………………… Read Before use ……......................... Declaration of Conformity (CE) ………………………………………………………………………….. Product information ......................... Operation ............................Troubleshooting ………………………………………………………………………......After use …………………………………………………………………………………………………….
1. General Safety Warnings WARNING: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Keep this manual readily accessible for reference. ■Working area safety - Keep working area clean and well lit. - Do not operate power tools in the presence of flammable liquids, gases or dust.
■Power supply Volume (mm) Load Output Weight Model Voltage Voltage Safety Approved Feature Length Width Height (AC) (DC) Adjustable stepless output voltage Available Input CB,CE,UL(CUL), APM-301C 100-240V 20-30V ROHS,REACH Voltage 110- 240VAC Automatic device application Screw fastening CB,CE,UL(CUL), AM-85 100-240V 20-30V check ROHS,REACH...
Page 6
Bit insertion: press the slide sleeve into the screwdriver and insert an appropriate bit. When the slide sleeve is released, the bit will be automatically locked. Illustration of insertion of bits Figure 1 Figure 2 Figure 3 Fastening and removing screw: To drive a screw, set the forward/reverse switch to the FWD position.
Replace the Carbon Brush: As illustrated below, insert a slotted hand screwdriver with 2~4mm head edge into the slot and open the carbon brush cover. Lift the carbon brush fastener spring. Loosen and pull the carbon brush guide cord to remove the carbon brush (Do not remove the insulation tape on the brush cover).
If the bit falls out easily or wobbles - Check that the bit matches our specifications. If not, change the bit to one that does. - Check that the bit is inserted tightly into two guide channels within the bit shaft. If not, remove the bit and re-insert it tightly.