Panasonic DMP-BDT281 Operating Instructions Manual page 29

System
∫ Easy Settings
You can execute basic settings.
∫ TV Settings
Press [OK] to show the following settings:
TV Aspect
Set to match the type of TV connected.
When connected to a 4:3 aspect TV and playing
16:9 ratio image:
The sides are
cut off so the
picture fills
4:3 Pan & Scan the screen.
When playing BD-Video,
video is output as "4:3
Letterbox".
Black bands
appear at
4:3 Letterbox the top and
bottom of
the picture.
When connected to a 16:9 widescreen TV and
playing 4:3 ratio image:
Video is displayed as a 4:3
16:9 ratio image in the centre of
the screen.
Video is displayed as a
16:9 full horizontally stretched 16:9
image.
TV System
Perform the setup so it matches the TV System
of the connected TV.
Screen Saver Function
This is to prevent image retention on the
screen.
≥ When this is set to "On":
If a list of playback content is displayed and
there is no operation for 10 minutes or more,
the screen switches to HOME menu
automatically.
≥ While playing and pausing, etc., this function
is not available.
On-Screen Messages
Choose whether to show status messages
automatically.
Settings
HDMI CEC
Set to use "HDMI CEC" function when
connected to a device that supports "HDMI
CEC".
≥ Select "Off" when you do not want to use
"HDMI CEC".
∫ Start-up Banner
Select whether to display the banner after turning
on this unit. ( 16)
∫ Quick Start
Speed of start-up from standby mode is
increased.
≥ When set to "On", the internal control unit will be
powered and in Network standby mode. The
idle power consumption will increase so
compared to when set to "Off".
(Power consumption
∫ Remote Control
Change the remote control code if other
Panasonic products react to this remote control.
∫ Firmware Update (
Press [OK] to show the following settings:
Automatic Update Check
When this equipment remains connected to the
Internet, it will check for the latest firmware
version when it is turned on and you can update
it if necessary.
Update Now
You can update the firmware manually if a
firmware update is available.
∫ System Information
Press [OK] to show the following settings:
Software Licence
Information about the software used by this unit
is displayed.
Firmware Version Information
Display firmware version of this unit and
wireless LAN module.
[BDT281/280]
∫ Default Settings
This returns all values in the Setup menu and the
Option menu to the default settings, except for
some settings of network, ratings, remote control
code, on-screen language, etc.
- 29 -
34)
14)