Table of Contents
Advertisement
4.2
Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3
Assembly/Panel Removal ( for 24"3011T
series)
Instructions below apply to the 24HFL3011T/12.
1
4.3.2
Speakers
Refer to
Figure 4-5
for details.
Caution: The Speaker connector on the SSB must be released
first before opening of Back cover, otherwise the Speaker cable
may be demaged
1. The speaker catch on the Back cover, Speaker cable
directly connected from Back Cover to SSB, so the cable
connector[1] form the SSB must be released first during
opening of Back cover. Refer to
2. Remove the fixation screws [2] that secure the speakers.
Refer to
Figure 4-5
3. Gently take the speakers out.
When defective, replace the whole unit.
2
Figure 4-4 Rear cover removal
Figure 4-5
for details.
for details.
Mechanical Instructions
4.3.1
Rear Cover
Refer to
Figure 4-4
Warning: Disconnect the Speaker cord before removing the
rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set.
2. At the indicated areas [2] the cover is secured by clips. Be
very careful with releasing those.
3. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
back to
div.table
TPN16.1HE LA
4.
for details.
2
EN 11
1
21400_106.eps
2016-Aug-19
Advertisement
Table of Contents
