Table of Contents
Advertisement
TROUBLESHOOTING
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfactory dry-
1)
ing result.
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
•
The set programme was incorrect.
•
The filter is clogged.
•
The condenser is clogged.
•
There was too much laundry in the appliance.
•
The drum is dirty.
•
Incorrect setting of the conductivity sensor
( See chapter "Settings - Adjustment of the
TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
12
Problem
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 19°C to 24°C.
Set the Time Drying or the Extra Dry pro-
2)
gramme.
remaining laundry moisture degree " for better
setting).
•
The airflow slots are clogged.
•
Room temperature is too low or too high
( optimal room temperature 19°C to 24°C )
850 x 600 x 540 mm (maximal 600 mm)
1030 mm
950 mm
Advertisement
Table of Contents
