Advertisement
01/16
Add-on modules-
Available by separate order for
communication and cloning.
Note: the USB port and an Add-on module cannot be physically connected at the same time.
Add-on: during installation
Installing an Add-on module requires sufficient clearance space
72 mm (2.835")
DIN-rail mounting
Snap PLC onto the DIN rail
Note: Removing the unit requires clearance space. Recommendation: approximately 40mm (1.58").
For UL listed module, in order to meet the UL508 standard, panel-mount this device on
the flat surface of a Type 1 enclosure.
Wiring
This equipment is designed to operate only in SELV/PELV/Class 2/Limited Power
environments.
All power supplies in the system must include double insulation. Power supply outputs
must be rated as SELV/PELV/Class 2/Limited Power.
Do not connect either the 'Neutral or 'Line' signal of the 110/220VAC to device's 0V pin.
Do not touch live wires.
All wiring activities should be performed while power is OFF.
Install an external circuit breaker. Guard against short-circuiting in external wiring.
Use appropriate circuit protection devices.
Unused pins should not be connected. Ignoring this directive may damage the device.
Double-check all wiring before turning on the power supply.
2
Add-on: after installation
27.5 mm
(1.083")
JZ20-T1X/JZ20-J-T1X/JZ20-J-T20HS
Integral USB Port
This may be used for
programming purposes.
USB Port
Panel mounting
Cut-out: 117 x 89mm (WxH)
(4.606"x 3.504")
Unitronics
Advertisement
