Display Functions - Miele 11070970 Operating Instructions Manual

Display functions

The display is used to select or set the
following:
– The programme
– The timer
– The
Settings 
The display can show the following:
– The stage the programme is at
– The estimated time left for the pro-
gramme to run
– The energy and water consumption
(EcoFeedback)
– Any relevant fault messages and in-
formation
To save energy, the dishwasher
switches off after a few minutes if you
do not press any sensor controls dur-
ing this time.
Touch the  sensor control to switch
the dishwasher back on.
Guide to the appliance
The OK sensor control is used to con-
firm a message or setting and also to
move to the next menu or another level.
Under  Further programmes/settings
the right of the display will show a scroll
bar . This offers further options. These
options can be shown using the
 sensor controls.
You can alter the dishwasher's controls
to suit changing requirements in the
Settings menu (see "Settings" chapter).
The option that is selected will have a
tick  next to it.
To exit a sub-menu again use the
 Back sensor control.
If you do not press any sensor controls
for several seconds, the display will re-
vert to the previous menu. You may
then have to enter your settings again.
These operating instructions apply to
several different dishwasher models of
different heights.
The different dishwasher models will
be named as follows:
normal = dishwasher measuring
80.5 cm high (built-in appliance)
or 84.5 cm high (freestanding appli-
ance)
XXL = dishwasher measuring 84.5 cm
high (built-in appliance).
17